Pedestal Assembly

 

Mount four 3" casters on the corners of a 2' by 2' by 3/4" piece of plywood. Install a 2" length of 4" PVC on a floor flange, and connect a 4" PVC male adapter to this. Center the floor flange on the 2' by 2' plywood, drill four holes, and secure with nuts and bolts. Cut a ½" piece off the end of a 3" PVC coupling. Install the ½" coupling piece flush to the top, on the inside, of a 48" long piece of 4" PVC. Install a 4" PVC female adapter to the other end of the 48" long piece of 4" PVC. Install the 3" PVC coupling, the ½" piece was cut off from, on to the bottom of a 45" length of 3" PVC. Insert the 45" length of 3" PVC, the end opposite the 3" PVC coupling, through the 4" PVC female adapter on the 48" length of 4" PVC up the inside of the 4" PVC, and out the top through the ½" 3" coupling piece. Sand down the inside of a 4" to 3" rubber flex coupling ,otherwise its near impossible to get on. Install the flex coupling over the 4" PVC and the 3" PVC. On the top of the 45" long 3" PVC install a 3" PVC male adapter.